Honda Harmony II HRT216PDA Owner's Manual page 12

CONTROLS
Drive Clutch Lever (SDA, TDA)
The drive clutch lever engages and
disengages the transmission that
drives the rear wheels. The drive
clutch lever should only be
engaged after the engine has been
started.
Shift Lever (TDA)
The shift lever is used to select the
ground speed. 1 is the slowest, 2 is
medium, and 3 is the fastest
setting. The shift lever may be
used any time a change in ground
speed is required.
Cutting Height Adjustment Levers
The mower deck can be set to any of the six approximate settings.
The adjusters move back to lower and forward to raise the mower
deck. Each wheel should be adjusted to the same position.
10
HRT
3/4" (19 mm)
1-1/4 " (29 mm)
1-3/4" (41.5 mm)
2-1/4" (54 mm)
2-3/4" (67 mm)
3-1/4 (79 mm)
REAR ADJUSTMENT LEVER
RIGHT SIDE SHOWN
DRIVE CLUTCH LEVER (SDA, TDA)
SHIFT LEVER (TDA)
HRS
1" (25 mm)
1-1/2 " (37 mm)
2" (50 mm)
2-1/2" (66 mm)
3" (75 mm)
3-1/2 (87 mm)
FRONT
ADJUSTMENT
LEVER