Bit Scsi (Not Sca2) Terminating Resistor Circuit - Fujitsu MAN3184 SERIES Specifications

Figure 1.16 shows the configuration of a SCSI terminating resistor circuit. The circuit shall be set
in either mode (by the CN2 setup pin) depending on the IDD system requirements.
Supply TERMPWR to SCSI Bus
Don't supply TERMPWR to SCSI Bus
Figure 1.16 16-bit SCSI (not SCA2) terminating resistor circuit
Notes:
All series have no internal terminator circuit. If the terminator circuit is needed, you
should add the external circuit on your system.
1-24
16-bit SCSI (P-connector) setting terminal
C141-E123-01EN
23 24
CN2 23-24pin
Short
Open