Fujitsu MAN3184 SERIES Specifications page 16

1.1 INFORMATION TRANSFER phase identification ....................................................................1 - 6
1.2 Single-Ended maximum distance between terminators ................................................................1 - 7
1.3 LVD maximum distance between terminators .............................................................................1 - 8
1.4 SE and LVD Transmission line impedance of cable at maximum indicated
data transfer rate.........................................................................................................................1 - 15
1.5 Attenuation Requiaments for SCSI cable media ........................................................................1 - 15
1.6 Output characteristic ..................................................................................................................1 - 19
1.7 Input characteristic.....................................................................................................................1 - 19
1.8 LVD DIFFSENS driver specifications.......................................................................................1 - 21
1.9 DIFFSENS receiver operating requirements..............................................................................1 - 21
1.10 Requirements for terminating resistor power supply..................................................................1 - 23
1.11 Setting set up pin, 16-bit (wide)/8-bit (narrow) mode................................................................1 - 25
1.12 Signal status at receiving end .....................................................................................................1 - 26
1.13 Signal driving method ................................................................................................................1 - 26
1.14 Bus phases and signal sources....................................................................................................1 - 27
1.15 SCSI bus control timing values..................................................................................................1 - 28
1.16 SCSI bus data & information phase ST timing values ...............................................................1 - 28
1.17 SCSI bus data & information phase DT timing values...............................................................1 - 29
1.18 Parameters used for fast synchronous data transfer mode..........................................................1 - 67
1.19 Retry count setting for RESELECTION phase ..........................................................................1 - 71
1.20 Maximum capacitance ...............................................................................................................1 - 97
1.21 System level requirements .........................................................................................................1 - 98
2.1 SCSI message...............................................................................................................................2 - 3
2.2 Extended message ........................................................................................................................2 - 4
2.3 Definition of data transfer mode by message exchange .............................................................2 - 17
2.4 Synchronous mode data transfer request setting ........................................................................2 - 19
2.5 Transfer mode setup request from INIT to IDD ........................................................................2 - 21
2.6 Transfer mode setup request from IDD to INIT ........................................................................2 - 23
2.7 Data bus width defined by message exchange ...........................................................................2 - 25
2.8 Wide mode setting request from the INIT to the IDD................................................................2 - 27
2.9 Wide mode setting request from the IDD to the INIT................................................................2 - 28
2.10 TRANSFER PERIOD FACTOR field.......................................................................................2 - 29
2.11 Valid protocol options bit combinations .................................................................................... 2 - 30
xiv
TABLES
C141-E123-01EN
page