Table of Contents
Advertisement
F.
Loosen bottom two screws shown in Figure 6.
screws.
G.
Remove the top two screws securing the back shroud. See Figure 7.
H.
Carefully slide rear shroud assembly upward and remove.
6. Install the weight stack.
A.
Note how the increment weights are installed.
B.
With an assistant holding the increment weights,
move the adjusting knob to 0 lbs. and remove all
six increment weights (three each side).
C.
Using an external snap ring pliers, remove the upper
snap ring from one of the guide rods and carefully
lower the guide rod. See Figure 8.
D.
Remove lower snap ring and wave washer from the guide
rod. Repeat steps 6C and 6D to remove both
snap rings from other guide rod.
E.
If possible, lean guide rods outward, away from
machine in order to provide the most room for
installing weight plates.
F.
Slide top weight up and out of machine and carefully set
it aside.
G.
Wipe guide rods clean over entire length. Lubricate with light coating of medium weight automotive
engine oil.
H.
Carefully install each weight plate one at a time.
edges of bushing face upward and narrow edges of bushing face downward. See Figures 9A and 9B.
Figure 9A
I.
Slide top weight onto guide rods.
J.
Place lower snap ring and wave washer onto guide rod (about 3" from the top end of guide rod).
K.
Raise guide rod up through mounting hole and install the upper snap ring.
Cybex Eagle 11020 Incline Pull Owner's Manual
NOTE: Do not remove the bottom two
NOTE: When installing weight plates, position plates so wide
WIDE bushing
edge faces
upward
Figure 7
Frame
Guide rod
Figure 8
NOTE: The narrow bushing
edge must face downward.
Figure 9B
Screw (loosen -
do not remove)
Figure 6
Screw
Upper snap ring
Wave washer
Lower snap ring
NARROW
bushing edge
Assembly
Page 4-3
Advertisement
Table of Contents
