FL5540 SUB-FRAME and
COUNTERWEIGHT
INSTALLATION/REMOVAL
1.
Remove the existing frame lower cover
and replace with the new lower cover
using existing mounting bolts and collar
washers.
Never operate the tractor without
the lower cover.
INSTALLATION INSTRUCTIONS
1. CLEAN THE CONTACT SURFACES BETWEEN BRACKET AND FRAME.
2. MOUNT THE BRACKET BY INSTALLING THE (8) BOLTS FINGER TIGHT.
3. TIGHTEN UNDERSIDE MOUNTING BOLTS: 29 ft-lbs. (39 Nm TORQUE).
4. TIGHTEN SIDE MOUNTING BOLTS: 29 ft-lbs. (39 Nm TORQUE).
THE TRACTOR FRAME CAN BE DAMAGED IF THE TRACTOR
IS MOVED WHILE THIS COVER IS OFF OR BOLTS ARE
NOT TIGHTENED TO THE PROPER TORQUE.
Note: A second label is included with this
operator's manual. Install this label onto the
original frame lower cover.
2. Remove the drawbar and replace it with
the bottom bracket using the two
12 x 25 mm hex hd capscrews with 7/16"
washers and two 10 x 30mm hex hd
capscrews with 3/8" washers.
Torque front cover and rear bracket bolts as
follows:
10mm Bolts 29 ft-lbs. (29 Nm).
12mm Bolts 43 ft-lbs. (60 Nm).
FL5540 SUB-FRAME and COUNTERWEIGHT INSTALLATION/REMOVAL
DRAWBAR
BOTTOM BRACKET
- -
NEW LOWER
FRONT COVER
BOLTS
13