Tractor Preparation - Honda FL5540KO Operator's Manual

TRACTOR PREPARATION

HARDWARE BAG CONTENTS
QNT'Y DESCRIPTION
7/16" lynchpin
5
2 10mm x 30mm hex hd capscrew
2 12mm x 25mm hex hd capscrew
2 1/2-13x11/2" hex hd capscrew
16 #11 clip pin
12 3/4 x 11/4 x 10 ga. machine bushing
2 1/2-13x13/4" hex hd capscrew
2 3/8" flat washer
2 7/16-14x11/4" hex hd capscrew
This loader is not intended to be used with any other attachments mounted on tractor.
REAR COUNTER WEIGHT
REFER TO OWNER'S MANUAL PROVIDED WITH TRACTOR.
The use of adequate rear counterweight is required for proper loader stability.
Refer to Tractor Owner's Manual for specific recommendations on counterweighting tractor.
Weight added to the rear of the tractor provides better traction and easier, more efficient loader
operation. The tractor must be counterweighted by installation of rear weights.
Additional counterweight requirements will vary with loader attachments and equipment
applications.
or may require more carefully restricted Operation at the rated load.
ROLL-OVER PROTECTION STRUCTURE (ROPS) SYSTEM
The tractor ROPS system must be in place and used properly to ensure adequate operator
protection.
LOADER HYDRAULIC SYSTEM
Follow recommendations in this operator's manual for hydraulic fluid specifications.
TRACTOR TIRES
Selection of tires should be restricted to.tire recommendations as specified by your
Tractor owner's manual.
Ag tires are recommended when using the front loader
TIRE INFLATION
Front tires must be maintained at the maximum recommended inflation with the added weight
of loader and material. Ag T ire pressure 34 psi.
Rear tires must be maintained at equal pressure within the recommended tire inflation range.
Ag Tire pressure 24 psi.
10
TRACTOR PREPARATION
DO NOT EXCEED THE RATING FOR MAXIMUM GROSS V EHICLE WEIGHT.
specific conditions may not permit safe use of loader at loader rating
7/16"—14 hex nut
2
7/16" lockwasher
2
1/2"—13 hex nut
4
1/2" flat washer
6
1/2" lock washer
4
5/16"—1 8 x 1 " hex hd capscrews
4
5/16" lockwasher
4
7/16" flatwasher
2
5/16"—18 13/4" hex hd capscrew
2
5/16" flatwasher
2
2
# 2 hose clamp
1
nylon tie