Honda FL5540K1 Operator's Manual page 22

FRONT LOADER ASSEMBLY
PRESSURE and SUCTION HYDRAULIC HOSE
CONNECTION
Remove the pipe plug from thevalve body
4.
and clean the threads and then install the
pressure hose. Remove the plastic caps
from the pump outlets. Use sealer on
threads and screw the other end (swivel
connector end) into the threaded pipe
fitting on the pump. Slide the suction hose
(large hose) over the pipe end at the
bottom of mastlreservoir and pipe end on
the pump. Attach with hose clamps and
tighten securely.
Attach the front guard on the front of the
5.
sub-frame using two each V2x1 inch and
inch bolts, and four each
inch nuts and washers. Do not tighten
bolts at this time.
ATTACHING LOADING MASTS
Move the tractor until the masts are
6.
positioned over the upright pads on the
sub-frame, use two people to lower the
masts onto the pads and insert the fixing
pins through the masts and pads. Install
clip pins to retain fixing pins.
Masts may have to be shaken to align fixing
pin holes.
20
HOSE CLAM
PUMP
FIXING PIN
HOSE
ESSURE
HOSE
SUCTION
CLIP PIN