Honda FL5540K1 Operator's Manual page 19

Remove the jack from the front. Push
11.
down on the front of the subframe while
pushing back. Slide the subframe into
the U-shaped channel. Place blocks un-
der the rear of the subframe.
Lift the front of the subframe with a jack
12.
and slip it into the channel of the lower
cover. Insert two
frame lower cover. Slip a 3/4in washer
over each mounting pin and insert the
clip pins through the holes.
Mounting pins have a flat side that must
be pointing down.
mounting pins
MOUNTING PIN
FLAT SIDE DOWN
17