Table of Contents
Advertisement
OPERATING INSTRUCTIONS
TRANSPORTING MATERIAL
Transport material to "unloading point" with
loader bucket as
low as
spillage
and
maintain
During transport the loader
a
should be in
position that will not impair
operator's vision.
Observe the following safety messages.
-Avoid any overhead wires or
obstacles when loader is raised, to avoid
damage or possible death by electrocution.
loaded bucket should be
- A
transported In a low position at slow ground
speeds, especially
if
Make turns slowly and use the tractor brakes
cautiously. Afull bucket in the raised position
alters the center of gravity of the unit and
increases the possibility of mishaps.
-do
not lift or carry personnel
on a loader or attachment; a slip or fall could
cause serious Injury.
UNLOADING
As the tractor approaches the "unloading
point", raise the loader to the height required
for
"dump"
clearance to
Drive slowly to position bucket above
"unloading point", stop tractor and dump
bucket.
For best stability, do not raise loader higher
than required for "dumping" Clearance.
As "dumping" clearance height increases, the
bucket position must be adjusted to maintain
a level bucket to prevent excessive spillage
of material from bucket.
30
possible to prevent
maximum
the ground
I s
Irregular.
bucket.
Advertisement
Table of Contents
