Stamina 55-1529A Owner's Manual page 9

Home gym

Hide thumbs

Table Of Contents

Table of Contents

ASSEMBLY INSTRUCTIONS

STEP 10:

Attach the

(M8 x 25mm)(46), WASHERS(M8)(51),

BOLTS.

STEP 11:

Slide the

ASSEMBLY,

and pull the covers down until the bottom of the covers are slightly lower than the

LINKAGES(3).

Make sure the

PROTECTIVE COVERS(26, 27).

LINKAGES(3)

with the

PROTECTIVE COVERS(26, 27)

NOTE: When the

(3)

should not be visible.

STEP 12:

Attach the

FRONT FRAME(1)

sides of the

STEP 13:

Verify that the handlebars function correctly before using the

the Nylon Bed on the

must move forward as the

ASSEMBLY STEPS 2, 10, 11, and 12.

forward check

Shaft

LINKAGES(7)

onto the

LEFT

RIGHT PROTECTIVE COVERS(26, 27)

and

SHAFTS

Secure the

SECURING STRAPS

LEFT

RIGHT HANDRAIL ASSEMBLYS(8, 9)

and

and then connect to the

MAIN FRAME(4)

backward toward the inverted position. The

MAIN FRAME(4)

Shaft

LEFT

RIGHT PIVOT ARMS(5, 6)

and

NYLOCK NUT(M8)(49).

and

FRONT FRAME(1)

on the

PROTECTIVE COVERS(26, 27)

on the covers.

are assembled correctly the

LINKAGES(7)

moves backward. If the

Nylon Bed

DO NOT OVER TIGHTEN THE

onto each side of the

poke out through the hole on the

to the

FOLDING LINKAGES

SHAFTS

onto the

LOCKING KNOBS(11).

with the

Assisted Inversion Pro.

HANDRAILS(10)

BOLTS

with

BASE

FOLDING

in both

Move

do not move

Table of Contents

Stamina 55-1529A Owner's Manual page 9

Related Manuals for Stamina 55-1529A

Related Products for Stamina 55-1529A

Table of Contents