Stamina 55-1529A Owner's Manual page 7

ASSEMBLY INSTRUCTIONS
STEP 4
FOOTREST(13)
Attach the
(47), WASHERS(M8)(51),
NOTE: The five holes in the
positions. Start with the center position and adjust if necessary. Use the outer position if users are
taller than average. Use the inner position if users are shorter than average.
STEP 5
OUTER PAD TUBE(15)
Insert the
INNER PAD TUBE(14)
the
TUBE(14), OUTER PAD TUBE(15)
BOLT(M6 x 42mm)(43), WASHERS(M6)(50),
with
WARNING: PAD TUBES(14, 15)
The
The ends must be pointed downward to properly secure the users feet in place during inversion.
Improper assembly will allow the user's feet to come loose and the user will fall from the
inversion table.
STEP 6
HEEL HOLDER TUBE(17)
Insert the
BOLT(M6 x 48mm)(44), WASHERS(M6)(50),
and secure with
HEEL HOLDER BRACKET(18)
TUBE(17)
together. Repeat on other side.
HEIGHT ADJUSTMENT BEAM(12)
onto the
NYLOCK NUTS(M8)(49).
and
FOOTREST(13)
allow the
through the hole on the
OUTER PAD TUBE(15).
into the
HEIGHT ADJUSTMENT BEAM(12),
, and
must be assembled with the ends pointed downward as shown.
through the hole on the
HEEL HOLDER(19),
onto a
FOOTREST(13)
HEIGHT ADJUSTMENT BEAM(12).
Align the holes on the
NYLOCK NUT(M6)(48).
and
HEIGHT ADJUSTMENT BEAM(12)
NYLOCK NUT(M6)(48).
and
then slide them onto
7
BOLTS(M8 x 50mm)
with
to be attached in three different
INNER PAD
then bolt them together
HEEL HOLDER
Insert
Place a