Stamina 55-1529A Owner's Manual page 8

ASSEMBLY INSTRUCTIONS
Buckle
1.
2.
Buckle
STEP 7
SPRING PIN(22)
Screw the
MAIN FRAME(4)
into
ADJUSTMENT BEAM(12)
MAIN FRAME(4).
back side of the
WARNING:
Do not use the
to use the proper height setting can result in difficulty recovering from the decline position. See
ADJUSTMENT
instructions on page 10.
STEP 8
NYLON STRAP(31)
Attach the
the end of the strap up through the bottom of the buckle, as shown in the illustration 1.
STEP 9
NYLON STRAP(31)
Hook the end of the
BUCKLE STRAP(32)
end of the
NYLON STRAPS
NOTE: The
a steeper decline angle, lengthen the straps. For a lessor decline angle, shorten the straps. Make
NYLON STRAPS
sure these
Assisted Inversion Pro.
A.
B.
C.
MAIN FRAME(4).
onto the
SPRING PIN(22)
by pulling the
as shown. For added safety, thread the
Assisted Inversion Pro
BUCKLE
onto the
onto the loop on the back of the
onto the loop on the
are used to control the decline angle of the
are tight in the buckle and check the decline angle before using the
HEIGHT ADJUSTMENT BEAM(12)
Install the
MAIN FRAME(4)
on the
SECURING KNOB(23)
until you have verified your height setting. Failure
BUCKLE STRAP(32)
on the end of the
FRONT FRAME(1).
8
and inserting the
by inserting
MAIN FRAME(4).
Assisted Inversion Pro.
HEIGHT
into the
HEIGHT
Hook the
For