Indoor Siren; Safety Warnings - Marmitek PH7208 User Manual

PH7208 ™ X-10 INDOOR SIREN

SAFETY WARNINGS

• To prevent short circuits, this product should only be used inside and only in dry
spaces. Do not expose the components to rain or moisture. Do not use the product
close to a bath, swimming pool etc.
• Do not expose the components of your systems to extremely high temperatures or
bright light sources.
• Do not open the product: the device contains live parts. The product should only be
repaired or serviced by a qualified repairman.
• In case of improper usage or if you have opened, altered and repaired the product
yourself, all guarantees expire. Marmitek does not accept responsibility in the case
of improper usage of the product or when the product is used for purposes other
than specified. Marmitek does not accept responsibility for additional damage other
than covered by the legal product responsibility.
• This product is not a toy. Keep out of reach of children.
• The sirens operate on 230V. When the housing is opened some components carry a very
high voltage! Only fit the sirens when the plug has been removed from the wall socket.
• The siren produces an extremely loud noise (110dB(A)). In order to prevent damage
to hearing never stand close to an operating siren!
INTRODUCTION
Congratulations on your purchase of the Marmitek X-10 wireless indoor siren PH7208.
This siren operates in response to X-10 commands. These commands are transmitted
onto the mains by Marmitek alarm systems or by a Marmitek SM10 interface. By using
a universal X-10 transmitter (Model SM10) this additional siren can therefore also be
connected to a security system other than a Marmitek X-10 system.
INSTALLATION
One or more additional sirens can be connected to a security system. In order to activate
them the so-called Unit and House Code on the alarm console or interface must be set to
the same address as the address on the siren. The standard factory setting is A-1. The
address can be set using the code dials. The PH7208 can be connected to any wall socket.
The Marmitek sirens operate without additional wiring. To do so a technology is used
whereby the command to activate the siren is transmitted through the mains. The con-
dition for this is that the sirens are connected to the same phase as the alarm system (or
another group within the same phase where appropriate). If this is not possible then
phase connection filters or repeaters should be used (e.g. FD10, CAT3000).
PH7208
™
3