Honda 08E55-S01-100H Installation Instructions Manual page 4

Intalling the LED
8. Measure and mark the upper steering column cover
removed in step 7, and lightly center-punch the
mark.
9. While wearing eye protection, drill a 5.5 mm hole
through the center-punched mark. Remove all burrs.
5.5 mm DRILL
CENTER OF
COLUMN COVER
MARK
10. Route the terminal ends of the LED through the hole
you just drilled, and secure the LED with the push
nut. Install the push nut securely.
LED
UPPER STEERING
COLUMN COVER
4 of 8
30 mm
UPPER STEERING
COLUMN COVER
PUSH NUT
AII 20465 (9908)
11. Carefully push the LED terminals into the 2-pin
connector from the kit.
Insert.
2-PIN
CONNECTOR
Firmly push the terminal into
the connector until they click
into position.
Installing the Disarm Switch
12. Mark the dashboard lower cover in the area shown.
While wearing eye protection, lightly center-punch
the mark, and drill a 12 mm hole through the center-
punched mark.
12 mm
DRILL BIT
DASHBOARD
LOWER COVER
© 1999 American Honda Motor Co., Inc - All Rights Reserved.
LOCK
Insert the tabs into the
grooves, slide the lock
toward the front, and press
down on the end.
WHITE WIRE
RED WIRE
14 mm
20 mm