Driver Installation - Manhattan 179225 User Manual

CE
This equipment is in compliance with the requirements of the following
regulations: EN 55022 Class B (2006); EN 55024 (1998+A1:2001+
A2:2003), (IEC/EN 61000-4-2 [1995+A1:1998+A2:2001)/-3(2006]).
C-Tick
This equipment is in compliance with the requirements of the following
regulations: EN 55022 (2006) Class B, AS/NZS CISPR22 © IEC: 2005.
VCCI
This equipment is in compliance with the requirements of the following
regulations: CISPR22 © IEC: 2005.

DRIVER INSTALLATION

Installing the device driver enables your computer's operating system
to recognize the Hi-Speed USB 2.0 SVGA Converter once it's connected.
Check your operating system and refer to the appropriate installation
procedure below to begin installing the device driver. IMPORTANT:
• Unplug the Hi-Speed USB 2.0 SVGA Converter from your PC or
notebook before executing any setup or un-install program.
• Make sure you connect the display device to the VGA (HD15)
connector of the Hi-Speed USB 2.0 SVGA Converter and switch it
on before plugging the converter into an available USB 2.0 port on
your PC or notebook (see Steps 6 and 7 below).
W 2000/XP
indoWs
1. Insert the enclosed driver CD into the CD-ROM drive. The setup
program should be launched automatically; if not, launch setup.exe
from your CD drive manually.
2.
When the InstallShield
Wizard welcome screen
displays, click "Next" to
continue.
3