Table of Contents
Advertisement
SoftwAre inStAllAtion
IMPORTANT: The software must be installed before the Converter is plugged in
to the computer.
1. Insert the included Cd into the computer's Cd-RoM drive. The auto-run setup
should automatically start; if it doesn't, browse to the Cd and manually launch
the Setup file.
2. When the InstallShield wizard starts and displays the initial Welcome screen,
click "Next."
3. When the license Agreement screen displays, check "I agree" and click "Next"
to advance to the Status screen, which will indicate the progress of the software
installation. NOTE: The installation can take several minutes.
4. When the Installation Complete screen displays, click "Finish." Depending on
your operating system, you may receive a prompt to re-start the computer.
HArdwAre inStAllAtion
IMPORTANT: The software must be installed before the Converter is plugged in
to the computer.
1. Connect the Converter to the monitor, lCd projector or other SVGA device, as
shown below.
2. Plug the Converter into a USB port on your desktop
or notebook computer. Windows will identify the
device and automatically detect and install the
necessary drivers and software. The Converter
is now ready to use.
Connects to any USB port
without conflicts or
external power supplies.
3
Advertisement
Table of Contents
