Modern computers are often not equipped with RS-232 ports, making the use of legacy peripherals and communication devices more difficult. The MANHATTAN USB to Serial Converter, with its serial RS-232 ports and speeds up to 225 kbps, easily expands a single USB 1.1 port to...
driver inStallation Prior to installing the driver, make sure the converter is not plugged in to the computer. When the install is complete, you’ll be prompted to make the connection at that point by plugging the flat connector into the computer’s USB port and plugging the square connector into the converter (on rear panel, shown above right).
Page 5
4. Select “Floppy disk drives” to indicate the driver location; click “Next.” 5. When the Driver Files Search Results screen displays, click “Next.”...
Page 6
6. When the Completing Found New Hardware Wizard the Found New Hardware Wizard screen displays, click “Finish” to complete the driver installation. Verification (for 2000) NOTE: This procedure is the same for Windows XP. 1. On the desktop, go to My Computer → Properties →...
Page 7
2. While in the same window as Step 1, double-click “Universal Serial Bus controllers” to confirm the appearance of Generic USB Hub “Generic USB Hub,” verifying a successful driver installation. Un-installation (for 2000) CD Drive (Varies) NOTE: This procedure is the same for Windows XP.
Page 8
For Windows XP 1. Insert the driver CD in your computer. 2. Select “Install from a list or specific location (Advanced).” 3. Click “Next” to continue. 4. Select “Search for the best driver in these locations” and “Include this location in the search:”...
Page 9
Verification (for XP) See Verification (for 2000). Un-installation (for XP) See Un-installation (for 2000).
SpeCifiCationS General • USB 1.1 • USB port; type B female • 4 RS232 ports; 9-pin male • 4 LED indicators; 1 power, 3 device • Transfer rate: up to 225 kbps • Bus powered • Over-current protection Dimensions • USB cable: 1.8 m (6 ft.) •...