Advertisement
43. Plug the 3-pin connector of the security system
wire harness into the 3-pin connector of the disarm
switch harness. Plug the 22-pin connector of the
security system wire harness into the control unit;
then reinstall the driver's dashboard lower cover.
SECURITY SYSTEM WIRE HARNESS
22-PIN CONNECTOR
DRIVER'S
DASHBOARD
LOWER COVER
44. Unplug the 4-pin connector from the right fuse box
and plug the 4-pin connector of the sub-harness
there.
SUB-HARNESS
4-PIN CONNECTOR
45. Push the clip of the sub-harness 4-pin connector
into the hole in the right front inner lower pillar.
12 of 12
DISARM SWITCH
3-PIN CONNECTOR
CONTROL UNIT
SECURITY SYSTEM WIRE
HARNESS 3-PIN
CONNECTOR
VEHICLE
4-PIN CONNECTOR
HOLE IN
INNER
LOWER
PILLAR
SUB-HARNESS
46. Route the sub-harness along the vehicle harness.
Inside the glove box, locate the 2-pin connector
blue-taped to the vehicle harness, and remove the
blue tape to free the connector. Plug the 2-pin
connector of the sub-harness into the 2-pin
connector you just freed.
BLUE TAPE
(Remove.)
47. Secure the sub-harness to the vehicle with three
short wire ties.
48. Open the hood, and attach the cover on the
bulkhead center stay.
BULKHEAD
CENTER STAY
49. Check that all wire harnesses are routed properly
and all connectors are plugged in.
50. Reinstall all removed parts.
51. Reconnect the negative cable to the battery.
52. Enter the customer's radio anti-theft code, if
applicable, and reset the radio station presets.
53. Reset the clock.
54. Check operation of the security system according
to the Owner's Manual supplied.
All 21624 (0008)
SUB-
HARNESS
SHORT
WIRE TIES
© 2000 American Honda Motor Co., Inc - All Rights Reserved.
2-PIN
CONNECTOR
VEHICLE
HARNESS
COVER
Advertisement
