Table of Contents
Advertisement
CAUTION
For continued safety, replace with a lamp
assembly of same type.
Allow a projector to cool for at least 45 minutes
before you open Lamp Cover. Inside of a
projector can become very hot.
CAUTION
Do not drop a lamp assembly or touch a glass
bulb! Glass can shatter and may cause injury.
Be sure to reset Lamp Counter when Lamp Assembly is replaced. When Lamp Replace Counter is reset, LAMP
REPLACE indicator stops lighting.
1
Turn projector on, press MENU button and ON-SCREEN
MENU will appear. Press POINT LEFT/RIGHT button(s) to
move a red frame pointer to SETTING Menu icon.
2
Press POINT DOWN button to move a red frame pointer to
"Lamp counter reset" and then press SELECT button.
3
Move arrow to replaced lamp number (Lamp 1, Lamp 2, Lamp 3
or Lamp 4) and then press SELECT button. Message "Lamp
replace counter Reset?" is displayed. Move pointer to [Yes] and
then press SELECT button.
NOTE: Be sure to reset correct lamp number otherwise LAMP
REPLACE indicator continues lighting.
4
Another confirmation dialog box appears and select [Yes] to
reset Lamp Replace Counter.
Do not reset Lamp Replace Counter except after Projection lamp is
replaced.
ORDER REPLACEMENT LAMP
Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the
following information to the dealer.
●
Model No. of your projector
●
Replacement Lamp Type No.
LAMP REPLACE COUNTER
:
LC-XT4U / LC-XT4E
:
POA-LMP100
- 11 -
CAUTION
HIGH VOLTAGE
HOT
Move pointer to Lamp counter reset and
then press SELECT button. Move
1
3
arrow to replaced lamp number (Lamp
2
4
1, Lamp 2, Lamp 3 or Lamp 4) and then
press SELECT button.
1
3
2
4
(Service Parts No. 610 327 4928)
Lamp Replacement
Message "Lamp replace
counter
Reset?"
is
displayed. Move pointer
to [Yes] and then press
SELECT button.
Select [Yes] to
activate it.
Advertisement
Table of Contents
