Assembly; Part Identification Chart - Pro-Form PFTL79020 User Manual

ASSEMBLY

Assembly requires two persons.
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is
coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the
top of the walking belt or the shipping carton. This is a normal condition and does not affect treadmill perfor-
mance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild,
non-abrasive cleaner.
Assembly requires the included allen wrenches
and wire cutters
Use the drawings below to identify the hardware used during assembly.
check to see if it has been preattached to one of the parts to be assembled.
Extension Leg Bolt (96)–4
1/4" Washer Internal Star
(39)–4 Washer (77)–4
1. Make sure that the power cord is unplugged.
With the help of a second person, carefully raise the
Upright Base (97) to the position shown. Insert one of
the Extension Legs (92) into the Upright Base. (Note: It
may be helpful to tip the Upright Base forward as you in-
sert the Extension Leg.) Make sure that the Warning
Decal (91) is in the indicated location.
Insert the other Extension Leg (not shown) in the same
way.
Set the treadmill in a cleared area and remove all packing materials. Do not
.
and your own phillips screwdriver
Note: If a part is not in the parts bag,
1" Tek Screw (80)–2
Upright Bolt (76)–4
1
91
5
97
92