Advertisement
4. Insert support arm (H) Fig. 7, into clamping brackets
(E) and tighten hardware just enough to hold support
arm in position.
5. The support arm (H) Fig. 7 should be positioned to
its approximate maximum height in set-up. (Information
regarding the adjustment of height of the support arm
can be found on page 4 of this instruction sheet).
After the support arm is in position, tighten all mounting
hardware that attaches the mounting brackets and sup-
port arm to the lathe.
6. Place the horizontal bar (L) Fig. 8, of shield assem-
bly into channel (J) Fig. 9, of support arm (H).
7. Make certain the bottom of wire backscreen (N)
Fig. 10, rests inside bracket (P) of support arm (H).
8. Insert two 1-1/2" hex head screws (M) Fig. 9, into
the channel (J) of the support arm (H) and tighten.
NOTE: The entire safety shield assembly can be shifted
by loosening the two screws (M) Fig. 9, and sliding
the safety shield assembly. Tighten two screws after all
adjustments.
K
N
P
J
M
3
E
Fig. 7
L
Fig. 8
Fig. 9
H
Fig. 10
H
Advertisement
