Reverting To Factory Defaults; Rebooting The Device - BARIX EXSTREAMER WIRELESS User Manual

7.11 Reverting to factory defaults

Click on the DEFAULTS button to enter the defaults page.
You will see the following screen:
Click on "Factory defaults" to revert all settings except
"Network configuration" to factory defaults.
While restarting the device the following screen appears
showing a number counting down:
Upon start up the following screen appears stating the
successful reverting to factory defaults:
Hard default settings
To revert all settings (including the network settings) to
factory defaults the Reset button has to be pressed for
about 5 seconds while the Exstreamer is powered.
Important note
Use this method if connection to the Exstreamer cannot be
established.
This can happen if you have set a Static IP address once,
switched off Sonic IP and then forgotten the IP address.
The Hard default settings sets the IP Address to automatic
discovery (0.0.0.0) and enables Sonic IP.
If this fails we recommend to download the Exstreamer
Digital Rescue Kit from www.barix.com. This Rescue Kit
reloads the entire firmware using the supplied serial cable.
Unzip the Kit and read "readme1st.txt" for instructions.
Exstreamer User Manual Version 1.7

7.12 Rebooting the device

Click on the REBOOT button to enter the reboot page.
You will see the following screen:
Click "Reboot the device" to restart the Exstreamer.
While restarting the device the following screen appears
showing a number counting down:
Upon start up the following screen appears stating the
successful restart: