Advertisement
Programming and User Codes
All locks are pre-programmed with a programming code and two user codes. The programming code and user codes can be changed at
any time.
Programming Code
• Used to manually program the lock using the keypad.
• Used to put the lock into enrollment mode.
• Can only be changed by manually using the keypad. See
• CANNOT be used to unlock the lock.
• CAN be used to take a lock out of vacation mode at the keypad. See
• If you change your programming code and then forget it, you can reset your lock back to factory settings. See
Settings
on page 4 for more information.
• The web interface is not affected by a change to the programming code.
User Codes
• Used to unlock the lock.
• May be added and deleted manually, using the keypad.
• User codes are assigned to names in the web portal and can be changed, added or deleted using the web portal.
• If you add a new code to the lock manually, the new code will be displayed on the web portal with an assigned name of
(#), which can be changed at any time.
Turn Lock Feature
When the Turn Lock feature (available on BE369 Deadbolt only) is disabled, a valid user code must be entered at the keypad in order to
lock the lock from the outside.
The Turn Lock feature is enabled by default.
Manual Programming Functions
See
Manual Programming Functions
on page 5 for instructions to disable this feature.
on page 5 for more information.
Vacation Mode
on page 4 for more information.
Restoring Factory
New User
2
Hide quick links:
Advertisement
