Table 4.121 Self-Test - Fujitsu MAX3036RC SERIES Specifications

Details of the address conversion algorithm executed when this parameter
page is specified and the data format, etc. of the conversion results reported
to the INIT are explained in RECEIVE DIAGNOSTIC RESULTS command
(Section 4.4.2).
(3) Logical unit Self-Test
When "0" is specified in the "SelfTest" bit and the values other than zero is
specified in the "SELF-TEST Code" field in CDB, the IDD executes the Self-Test
specified in CDB. In this case, the INIT can read the executed results (page
code= x10 : Self-Test Result Log Page) by the LOG SENSE command.
The specified values in "PF" bit, "DevOffL" bit and "UnitOffL" bit in CDB are
ignored.
The "Parameter List length" field shall contain zero. If the value other than zero
is specified in this field, this command is terminated with a CHECK
CONDITION status (ILLEGAL REQUEST [=5] / Invalid field in CDB [=24-00]).
The "SELF-TEST Code" field specifies the type of executing Self-Test by this
command, as Table 4.121.
Page code
(Hex)
0,0,0 Refer to clause (2), Parameter Specification.
0,0,1 The device server shall start its short self-test routine in the background mode.
0,1,0 The device server shall start its extended self-test routine in the background
mode.
0,1,1 Reserved
1,0,0 Abort the current self-test running in background mode. This value is only valid
if a previous this command specified a Background self-test function and that
function has not completed. If either of these conditions is not true, then the
device server shall it respond by returning a CHECK CONDTION status.
1,0,1 The device server shall start its short self-test routine in the foreground mode.
1,1,0 The device server shall start its extended self-test routine in the foreground
mode.
1,1,1 Reserved
C141-C012
4.4 Maintenance, Diagnostic Commands

Table 4.121 SELF-TEST

Function
4-181