Features Introduced In This Release; Release 3.1.4.16; Release 3.1.4.8; Release 3.1.4.5 - Dell PowerConnect 8024 Release Notes

PowerConnect 8024/8024F Release Notes

Features Introduced in this Release

Release 3.1.4.16

No new features introduced in Release 3.1.4.16.

Release 3.1.4.8

No new features introduced in Release 3.1.4.8.

Release 3.1.4.5

 New PowerConnect 8024 Switch
A 24 port 10GBase-T (1Gigabit/10Gigabit) switch with 20 fixed 10GBase-T ports and 4 combo ports that
can be either 10GBase-T or SFP/SFP+. There are two redundant power supplies each of which can supply
300W. For management there is one RS232 console port and an OOB port.
 Fiber ports support 1Gigabit and 10Gigabit Transceivers
The PC8024/PC8024F support 1Gigabit SFP and 10Gigabit SFP+ transceivers on fiber ports. The following
table explains the supported transceivers and their capabilities on fiber ports.
Module Type
SFP
SFP+
 RTAG7 Hashing Mode Support
Port Channels now can use the RTAG7 hashing support for improved load sharing.
There are several configurable RTAG7 options such as packet field selection, source and destination port
numbers, XOR and CRC algorithms, and modulo operation. The RTAG7 settings apply to both Trunk
hashing and ECMP hashing. There cannot be 2 different RTAG7 settings for LAGs and ECMP.
Page 4
Negotiation Support
Yes
No
Default Negotiation
Enabled
Not Applicable
System Firmware Version 3.1.4.16
Supported Speeds
1G
10G