New In This Release - Dell S6100 Release Notes
Hide thumbs
Also See for S6100:
- Configuration manual (1743 pages) ,
- Installation manual (54 pages) ,
- Configuration manual (999 pages)
Advertisement
•
Two small form-factor pluggable plus (SFP+) 10G ports
•
Two AC or DC power supply units (PSUs)
•
Four fans with airflow from the I/O side to the power supply unit (PSU) side or from the PSU side to
the I/O side (optional fan subsystem available)
The following lists the individual Dell S6100–ON system hardware components that are available to
order:
•
Fan with airflow from I/O side to PSU side (red — normal air flow direction)
•
Fan with airflow from PSU side to I/O side (blue — reversed air flow direction)
•
AC or DC power supply with airflow from I/O side to PSU side
•
AC or DC power supply with airflow from PSU side to I/O side
NOTE: Fan modules and power supplies are field replaceable units.
NOTE: All fans and PSUs must have the same airflow direction. If you mix the airflow direction, the
switch detects the discrepancy, issues an alarm, and may auto-shutdown to avoid heat damage to
components. You must correct the mixed airflow direction.
Software Requirements
Table 2. Software Requirements
Software
ONIE
DIAG-OS
New in This Release
The S6100–ON offers the following new features and enhancements.
This is the initial release of the S6100–ON. See this section in later versions of this Release Note.
Initial Release
This is the first release of the S6100–ON system.
For more information about the S6100–ON, see the following documents:
•
Dell Installation Guide for the S6100–ON System
•
Dell Getting Started Guide for the S6100–ON System
•
Open Networking Hardware Diagnostic Guide for the S6100–ON System
•
Dell Command Line Reference Guide for the S6100–ON System
•
Dell Configuration Guide for the S6100–ON System
Important Information
The following is important information you need to know when working with your system.
I2C Bus
NOTE: After a thermal shutdown, the I2C bus could lock up occasionally. If this happens, you must
manually power cycle the system.
2
Minimum Release Requirement
v3.25.1.2 (Based on the ONIE forum release 2015.05)
v3.25.3.2
Dell Release Notes for the S6100–ON System
Advertisement
