[Auto Setup]; [Output Resolution] - Panasonic ET-YFB100G Operating Instructions Manual

[AUTO SETUP]

Sets the auto setup function. Set it to [AUTO]
normally.
1) Press ▲▼ to select [AUTO SETUP].
2) Press the <ENTER> button.
z The [AUTO SETUP] screen is displayed.
3) Press ▲▼ to select [AUTO SETUP
SETTING].
4) Press ◀▶ to switch [AUTO SETUP
SETTING].
z The setting will change as follows each time
you press the button.
[AUTO]
When the projecting image signal
is changed to the computer signal,
[AUTO]
the auto setup function starts
operating.
Manually enables the auto setup
function.
[MANUAL] Refer to Steps 5) to 7) of "When
manually enabling the auto setup
function" for details of this item.
■ When manually enabling the auto
setup function
5) Select [MANUAL] in Step 4).
6) Press ▲▼ to select [AUTO SETUP].
7) Press the <ENTER> button.
Note
z This function is supported only when the computer
signal and the HDMI signal is input.

[OUTPUT RESOLUTION]

Sets the resolution of the image output from the
<DIGITAL LINK> terminal.
1) Press ▲▼ to select [OUTPUT
2) Press the <ENTER> button.
3) Press ▲▼ to select a setting item.
[MANUAL]
4) Press the <ENTER> button.
Note
z When set to [AUTO], the output resolution varies
z When set to [AUTO], the image is automatically
z When [OUTPUT RESOLUTION] is set to any item
[OPTION] menu
RESOLUTION].
z The [OUTPUT RESOLUTION] screen is
displayed.
[AUTO] Sets the resolution automatically.
Outputs in WUXGA (1 920 x 1 200
[1920x1200]
dot) standard.
Outputs in 1080p (1 920 x 1 080
[1920x1080]
dot) standard.
Outputs in WXGA (1 280 x 800
[1280x800]
dot) standard.
Outputs in XGA (1 024 x 768 dot)
[1024x768]
standard.
depending on the input signal.
• 720/1080 signals: Outputs the image as it is.
• 480/576 signals: Outputs the image converted to
1080p.
• Other signals:
Outputs the image converted to the panel
resolution of the projector. If the panel resolution
of the projector is unknown, the signals are output
in 1 024 x 768.
output in the resolution and tone appropriate for
the projector, but it takes while to output the image
when switching the input. If set to any item other
than [AUTO], the motion of the image may be
unnatural when movie based signals are input, but
the time to switch the input can be reduced.
other than [AUTO], the image is not projected
depending on the connected projector.
In this case, to return the [OUTPUT RESOLUTION]
setting to [AUTO], press the <RETURN> button
on the control panel for three times and then press
the <ENTER> button and the <RETURN> button
simultaneously.
ENGLISH - 39