Mounting Collar; Mounting Spring; Mounting Bolt (5 Mmø); (5 Mmø X 16 Mm) - Panasonic CQ-VD7001W Operating Instructions Manual

Installation
(continued)
Mounting the Display Unit
Installation Procedures (When using Mounting Collar w)
Note:
¡The car model, installation condi-
tions and combination of the units
used may impose some restric-
tions on opening and closing the
monitor as well as on the angle
and position to which the monitor
can be adjusted.
IMPORTANT
When this unit is installed in dash-
board, ensure that there is sufficient
air flow around the unit to prevent
damage from overheating. Do not
block any ventilation holes on the
unit.
r Mounting Bolt
(5 mmø)
!3 Power Connector
e Mounting Spring
o Flat-Head Screw
(5 mmø x 6 mm)
60
CQ-VD7001W
1
Insert the Mounting Collar w into the dashboard, and
bend the mounting tabs out with a screwdriver.
Fastening the Mounting Collar w
How much to bend the tabs will vary depending on the
car. Bend them with a screwdriver to fasten the
Mounting Collar w securely in the dashboard.
Dashboard
w Mounting Collar
Tab
2
Attach the Mounting Springs e to the unit.
Establish the rear connection of the unit.
3
After fixing Power Connector !3 , fix the rear of the unit to
the car body by either method (a) or (b) shown at right.
Insert the unit into Mounting Collar w.
4
Secure the clamp plate of Mounting Collar
w to the hook of Mounting Spring e .
Clamp plate
5
Insert Trim Plate q.
6
After installation
reconnect the negative
(–) battery terminal.
Method for Fixing the Mounting Spring
Two holes of the mounting spring allow you to select between two mounting types as shown below.
(A) Regular installation method
A few millimeters of
console projecting
o Flat-Head Screw
o Flat-Head Screw
Method for Fixing the Rear of the Unit
(a) Using the Rear Support Strap u.
Fire wall of car
3 mm ø
u Rear Support Strap
t Tapping Screw
(5 mmø x 16 mm)
y Hex. Nut
(5 mmø)
r Mounting Bolt
(5 mmø)
(B) Deeper installation method
Less projecting
o Flat-Head Screw
o Flat-Head Screw
Caution
¡Method (B) is not available in some types of cars.
(b) Using the Rubber Cushion (option)
Rear Support Bracket
(Provided on the Car)
Rubber Bushing
(option)
r Mounting Bolt
(5 mmø)
CQ-VD7001W
61