Electric Power; Power Connection Wiring - Trane Packaged TerminalAir Conditioners & Heat Pumps Installation Operation & Maintenance

Packaged terminal air conditioners & heat pumps

Hide thumbs

Table Of Contents

Table of Contents

Table EP-1 — Electric Heat Capacity and Electrical Data (For PTEC and PTHC Models)***

Electric

Heater

No. Of

Voltage

Size (kW)

Stages

208/230

2.0/2.5

208/230

2.9/3.5

208/230

4.1/5.0

265

2.5

265

3.7

265

5.0

Notes:

1. Minimum branch circuit ampacity ratings conform to the National Electric Code. However, local codes should apply.

2. Minimum voltage on 208/230 volt models is 197 volts; maximum is 253 volts. Minimum voltage on 265 volt models is 238.5 volts; maximum is 291.5 volts.

3. Overcurrent protection for all units without electric heaters is 15 amps. Overcurrent protection on 265 volt models must be cartridge-style time delay fuses (included and

factory installed on Trane chassis).

4. Total watts for 7,000 and 9,000 Btu models; add 40 watts for size 12 and 70 watts for size 15.

**PTHC07, 09 and 12 are two-stage; PTHC15 is one-stage.

*** Note: All heat pumps must have electric coils.

Table EP-2 — Power Receptacle Configurations

Voltage

Unit Supplied Plug

Amps

NEMA Rating

6-15P

Receptacle

Amps

NEMA Rating

6-20R

Notes:

1. All wiring, including receptacles, must be made in accordance with local electrical codes and regulations.

2. NEMA 6-15 and 6-20 plugs fit in NEMA 6-20 receptacles.

3. Receptacles shown for 208/230 applications are factory supplied with subbase, per local codes for wall mounted receptacles use or the corresponding NEMA receptacles.

4. Receptacles shown for 265 volt applications are factory supplied with subbase. Codes do not allow 265 volt units to mate with wall mounted receptacles. They may however be

hard-wired per Local Codes.

PTAC-PRC001-EN

Electric

Power

Nominal Heating

Btu 208

Btu 230

6,800

8,500

9,900

12,000

14,000