F12] : End Setting - FujiFilm FinePixS5000 Service Manual

FinePix S5000 Service Manual

4-18. [F12] : End Setting

(Destination setting, USB ID write, Product mode setting)
1. The End setting consist of the following settings.
* Destination setting
* USB ID write
* Product mode setting (mass storage identification)
2. The setting must always be run when the adjustment soft-
ware is terminated. Failure to run Terminal Setting will pre-
vent identification as Mass Storage when the camera is con-
nected to the PC.
3. USB ID write details
1) USB ID write requires that the USB device (in this case
FinePix A303) be unique throughout the world. For this
reason, each device has a unique ID as determined by
the USB standard. If multiple devices with the same USB
ID are connected to a single PC, the PC will be unable to
identify each USB device, thus preventing operation.
<Step 1>
Select [F12] from [Adjustment item Select Screen (Fig.5)] (ie press the [F12] key on the computer).
---> The [End Setting Start Screen (Fig.37)] is appears.
<Step 2>
Follow instructions on the [End Setting Start Screen (Fig.31)], and press the [Enter] key.
4. Adjustments
2) Automatically written USB IDs are as follows.
Item
Repair Date Date information is acquired from
the PC and written.
Administrator ID C(43)
Repair Sapporo:30(0)
Site Sendai:31(1)
Tokyo:33(3)
Nagoya:34(4)
Osaka:35(5)
Hiroshima:37(7)
Fukuoka:38(8)
U.S.A.:61(a)
Canada:62(b)
Hawaii:63(c)
Taiwan:64(d)
China:74(t)
England:66(f)
Germany:67(g)
France:68(h)
Spain:69(i)
Italy:6A(j)
Netherlands:6B(k)
Belgium:6C(l)
Sweden:6D(m)
Switzerland:6E(n)
Norway:6F(o)
Finland:70(p)
Singapore:71(q)
Others:7A(z)
Repair A serial No. is assigned
SerialNo. automatically and written
Numbers in ( ) indicate decimal numbers. Other numbers are
ASCII numbers.
Fig.37
Details
65