FujiFilm FinePixS5000 Service Manual page 2

SAFETY CHECK-OUT
1. Check the area of your repair for unsoldered or poorly
sol dered connections. Check the entire board sur-
face for solder splasher and bridges.
2. Check the interboard wiring to ensure that no wires
are "pinched" or contact high-wattage resistors.
3. Look for unauthorized replacement parts, particuarly
tran sistors, that were installed during a previous re-
pair. Point them out to the customer and recommend
their replacement.
4. Look for parts which, though functioning, show ob-
vious signs of deterioration. Point them out to the
customer and recommend their replacement.
5. Check the B + voltage to see it is at the values speci-
fied.
2
After correcting the original problem, perform the following
safety check before return the product to the costomer.
FinePix S5000 Service Manual
6. Make leakage - current measurements to determine
that exposed parts are acceptably insulated from
the supply circuit before returning the product to the
customer.
7.
RISK OF FIRE-
REPLACE FUSE
2.5A 125V
AS MARKED
2.5A 125V
8.
WARNING!
HIGH VOLTAGE
CAUTION: FOR CONTINUED PRO-
TECTION AGAINST FIRE HAZARD,
REPLACE ONLY WITH SAME TYPE
2.5 AMPERES 125V FUSE.
ATTENTION: AFIN D'ASSURER
UNEPROTECTION PERMANENTE
CONTRE LES RISQUES D'INCENDIE,
REMPLACER UNIQUEMENT PAR UN
FUSIBLE DE MEME, TYPE 2.5 AM-
PERES, 125 VOLTS.
WARNING:
TO REDUCE THE ELECTRIC SHOCK,
BE CAREFUL TO TOUCH THE PARTS.