FujiFilm FinePixS5000 Service Manual page 38

4. Adjustments
(2)Setup for AF adjustment (Fig.B)
1. Set the distance between the conversion lens and
the tip of the lens to 900mm±2mm.
2. Use a light source to illuminate the AF chart. Ensure
that the luminance of the surface of the AF chart is
between 9.0Ev and 12.0Ev.
3. Ensure that the conversion lens is concentric with
the camera lens.
Base plate
(3)Setup for Flash Adjustment (Fig.C)
Strobe adjustment is readily influenced by external light.
The periphery of the gray chart should therefore be as
dark as possible to minimize this influence.
Ensure that the gray chart is at a distance of 1000mm
from the camera reference face (*1). Use a Superior
Oxford Gray (No.22) chart, or a chart with reflectivity of
18±0.7%.
(4)Preparation for AF-Assist Light adjustment
1. Output the image to TV with a camera that works
normally.
2. Apply the sign according to the mark of the center of
the AF target [+].
(5)Setup for AF-Assist Light adjustment (Fig.D)
1. Set the distance between the Line Chart and the tip
of the lens to 932mm±2mm.
2. Use a light source to illuminate the Line chart.
Ensure that the luminance of the surface of the Line
chart is between 9.0Ev and 12.0Ev.
(Darken the lighting for the irradiation positioning
after suitable of the auto focus.)
38
Lens holder
Stand
When assembling the
conversion lens, take care to
ensure that the protruding
side is towards the subject,
and the flat side is towards
the camera lens.
FinePix S5000 Service Manual
Fluorescent light stand
Conversion lens
Camera
900mm±2mm
A
Conversion lens Distance A
1560.69mm 25.16mm
865.12mm 30.64mm
<Fig.B> Setup for AF Adjustment
1000±10mm
Camera
<Fig.C> Setup for Flash Adjustment
Fluorescent light stand
Center
Camera
932mm±2mm
<Fig.D> Setup for AF-Assist Light adjustment
AF chart
Center
Center
Gray chart
Line chart