Advertisement
Initialization
Follow steps 1 through 7 to initialize
or re-initialize the remote with the
fireplace:
①
Plug cord into 120 Volt wall outlet.
②
Ensure the Main On/Off Switch
located in the switch box on the
fireplace in the lower right hand
corner is in the
ON position
(Figure 2).
Figure 2
A
B
A. Main On/Off Switch
B. 3 Position Switch
C. Initialization Button
③
Set the 3 Position switchl to the
Remote position (right position).
④
Press and hold the Initialization
Button on the unit (Figure 2).
⑤
While holding the Initialization
Button, press the Flame & Heat On/
Off button or the Purifire™ On/
Off
button
on the remote control
transmitter.
⑥
Release the Initialization Button on
the unit.
⑦
Press the Flame & Heat On/Off
button to turn the flame/heat function
on or press the Purifire™ On/Off
button
to turn the Purifire™ function
on.
2
Battery Replacement
①
Depress tab on the Battery Cover on
the back of the remote transmitter
and remove battery cover (Figure 3).
Figure 3
C
②
Replace the two (2) AAA batteries
into the remote control as shown in
Figure 4.
Figure 4
③
Ensure child lock is in the "unlocked"
position (Figure 1, page 1).
④
Replace the battery cover.
!
NOTE: When the "BAT" symbol
is present on the remote control
it is recommended to replace the
batteries promptly, to maintain full
functionality of the remote/fireplace.
The remote transmitter has a battery
backup time of only several hours.
Battery must be recycled or
disposed of properly. Check with
your Local Authority or Retailer
for recycling advice in your area.
Frequency Interference
If the fireplace does not respond
properly to the remote control, the
remote operating frequency may have
to be reset. The remote control can
send another frequency code to the
circuit board to eliminate interference.
①
Battery Cover
Tab
②
③
④
⑤
Your remote will now have a different
Batteries (2)
frequency communicating with the
fireplace.
Child Lock
Simultaneously press the
O. Sleep Timer Down button and
the Q. Purifire™ Speed Down
button on the remote control (refer to
the Operation section on page 1 for
a description of the remote's buttons
and functions).
"COD" will appear in place of the
sleep timer digits.
Release the Sleep Timer Down and
the Purifire™ Speed Down buttons.
Press the Initialization Button on the
fireplace (Figure 2-C).
Press the Flame & Heat On/Off
button on the remote.
www.dimplex.com
Advertisement
