Oven Light; Troubleshooting - Maytag W10392926B User Instructions

The oven light is a standard 40-watt appliance bulb. Before
replacing, make sure the oven and cooktop are cool and the
control knobs are in the off position.
To Replace:
1. Unplug range or disconnect power.
The 120-volt appliance outlet located on the control console may
be used to run portable appliances placed on countertops beside
the range.
The outlet operates independently and is not affected by range
control settings.
NOTE: Do not place portable appliances on the cooktop. Damage
to the portable appliance could result if the cooktop is hot.
First try the solutions suggested here or visit our website and reference the Customer Service section to possibly avoid the cost
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Cooktop cooking results not
what expected
Oven will not operate
Oven temperature too high or
too low
Oven indicator lights flash
Oven control displays
messages
18

Oven Light

Appliance Outlets

TROUBLESHOOTING

of a service call.
www.maytag.ca
POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown, or a
circuit breaker is tripped.
The control knob is set
incorrectly.
The cooktop control lockout is
set.
Cooktop is turned off.
Improper cookware being used
Cooktop control set to incorrect
heat level
Range is not level.
The electronic oven control was
set incorrectly.
Delay Start was set.
The oven control lockout is set.
The range is in Demo Mode.
Oven temperature calibration
needs adjustment.
Needs service (oven indicator
lights are flashing).
Power failure (display shows
flashing time)
Error code (display shows letter
followed by number)
2. Turn the glass bulb cover in the back of the oven
counterclockwise to remove.
3. Turn bulb counterclockwise to remove from socket.
4. Replace bulb, then bulb cover by turning clockwise.
5. Plug in range or reconnect power.
(on some models)
Appliance Outlet Circuit Breaker:
The circuit breaker for the appliance outlet on your range is located
next to the outlet. It is rated for 12 amps.
If the circuit breaker trips, it can be reset by pressing the switch. A
delay of several minutes may be required for the circuit breaker to
cool before it will reset.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
Touch the display area on the control panel to select a cooking
surface before selecting a function.
See "Control Lock" in the "Cooktop Use" section.
The Power key was unintentionally touched. Press POWER
again. Reset the cooktop.
See "Cookware" section.
See "Cooktop Controls" in the "Cooktop Use" section.
Level the range. See the Installation Instructions.
See "Electronic Oven Controls" section.
See "Cook Time" section.
See the control lock keypad feature in the "Feature Guide"
section.
Demo Mode will deactivate all heating elements. See "Demo
Mode" in the "Electronic Oven Controls" section.
See "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Control Display" in the "Electronic Oven Controls"
section. If the indicator light(s) keeps flashing, call for service.
See cover for contact information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Press the CANCEL keypad to clear the display. See "Control
Display" in the "Electronic Oven Controls" section. If it
reappears, call for service. See cover for contact information.