Lenovo ThinkServer TS130 1098 Hardware Maintenance Manual page 88

Table 25. Submenus under the Serial Port Setup menu
Item
Serial Port1 Address
Note: [ ] indicates the default setting.
Table 26. Submenus under the USB Setup menu
Item
USB Support
USB Legacy Support
Front USB Ports
Rear USB Ports
USB Port 1
USB Port 2
USB Port 3
USB Port 4
USB Port 5
USB Port 6
USB Port 7
USB Port 8
Note: [ ] indicates the default setting.
Table 27. Submenus under the ATA Drive Setup menu
Item
External SATA Port
SATA Controller
Configure SATA as
Native Mode Operation
84
ThinkServer TS130 Hardware Maintenance Manual
Option
Disabled, [3F8/IRQ4], 2F8/IRQ3,
3E8/IRQ4, 2E8/IRQ3
Option
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
[Enabled] / Disabled
Option
[Enabled] / Disabled
[Enabled] / Disabled
IDE / [AHCI] / RAID
[Enabled] / Disabled
Description
Disable or select settings for Serial
Port 1.
Description
Enable or disable USB functions. If
it is disabled, no USB device can be
used.
Enable or disable the USB legacy
support. When the USB legacy
support is disabled, the USB
keyboard and mouse will not function
unless the device driver is installed.
Enable or disable front USB ports.
Enable or disable rear USB ports.
Enable or disable USB port 1.
Enable or disable USB port 2.
Enable or disable USB port 3.
Enable or disable USB port 4.
Enable or disable USB port 5.
Enable or disable USB port 6.
Enable or disable USB port 7.
Enable or disable USB port 8.
Description
Enable or disable the external SATA
port.
Enable or disable the SATA controller.
Select this option to configure your
system ATA drive.
Note: Device driver support is
required for AHCI and RAID.
Depending on how the hard disk
image was installed, changing this
setting may prevent the system from
booting.
Enable or disable native mode for
ATA.