Korg PA900 Quick Manual page 21

LEFT, RIGHT
Use these line-level outputs to send the final stereo mix to an
external device. Connect either of them to output the signal in
mono. Adjust the output level with the MASTER VOLUME
knob.
Connect two mono cables to these outputs. Connect the other
end of the cables to a stereo channel of your mixer, two mono
channels, two powered monitors, or the CD, LINE IN or TAPE/
AUX input of your audio system. Don't use the PHONO inputs
of your audio system!
Connecting a jack to these outputs will not deactivates the inte-
grated speakers. This way, you can continue to monitor your
playing, while the signal is sent to the main mixer.
AUDIO IN Section
Use these connectors to connect a
dynamic microphone, another key-
board/synthesizer, or a CD player.
LEFT, RIGHT
Use these connectors to connect a line-level input source, such
as a CD player or a synthesizer, or a dynamic microphone. The
signal routing, and the correct impedence for these inputs, can
be selected with the "Input Routing" parameter in the Global >
Audio & Video > Audio In page.
• When the "Input Routing" parameter is set to "Left In to Voice
Processor", you can connect a dynamic microphone to the LEFT
audio input. Use the MIC GAIN knob to adjust the input gain.
Set the volume level of the AUDIO IN signal in the mix by using
the MIC VOLUME knob, while watching at the AUDIO IN LED
on the control panel (see "Mic Setting Section" on page 15).
• When the "Input Routing" parameter is set to "Audio Ins to
Direct Out", you can connect a line-level input source to the
LEFT and RIGHT audio inputs. Use the source's output volume
control to adjust the input level, while watching at the AUDIO
IN LED on the control panel.
MIC GAIN
Use this controls to adjust the input sensitivity of the LEFT con-
nector (from 0 to +40dB) when it is set to the microphone input
sensitivity (see above). You can check the input level by watching
at the AUDIO IN LED on the control panel (see "Mic Setting
Section" on page 15).
Power
This is where you connect Pa900 to the power line.
ACV cable connector
Plug the supplied AC cable into this con-
nector. When the cable is connected, the
instrument is in standby mode. To let it
enter or exit standby, use the STANDBY
switch located on the front panel.
Warning: When the instrument is in standby mode, it is still con-
nected to the power line. Accessing the inside of the instrument can
be dangerous. To completely disconnect the instrument from the
power, unplug the power plug from the power socket on the wall.
Overview
17
Rear Panel