Base Station - RCA 25420 User Manual

Connections and Setup

Base Station

The phone must be connected to two line (RJ14C) wall jacks or four single line
(RJ11C) wall jacks to accomodate all four lines.
IMPORTANT: Connect the AC power supply to the base unit as out
lined in steps 1 through 3 below prior to connecting the telephone line
cords to insure for proper base station ID assignment.
1. Choose an area near an electrical outlet and a telephone wall jack, and place
your cordless telephone on a level surface, such as a desktop or tabletop.
2. Plug the power supply cord into the power jack on the back of the base and
the other end into an electrical outlet.
T-T009 power adaptor listed in the user's guide.This power adaptor is
3. Connect the telephone line cords:
of the straight telephone line cord tagged as "LINE 1+2" into the jack marked
LINE 1 + 2 and one end of the other straight line cord into the jack marked LINE
3 + 4 on the back of the base. Plug the other end of each line cord into the dual-
line wall jacks.
use adaptors or couplers (not included) to combine the four single telephone
lines into two dual lines. The adaptor/coupler may look similar to the one pic-
tured here and can be purchased from your local telephone products retailer.
9