Related Manuals for Clarke CAT108 (1/2)
Summary of Contents for Clarke CAT108 (1/2)
- Page 1 REVERSIBLE RATCHETS MODEL CAT108 (1/2”) & CAT109 (3/8”) Part Nos: 3120110 & 3120116 OPERATING & MAINTENANCE INSTRUCTIONS GC0409...
-
Page 2: Introduction
GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. -
Page 3: Table Of Contents
Bottle of Airline Oil • Operators Manual (this document) Your reversible ratchet has been designed to give long and trouble free service. If, however, having followed the instructions in this booklet carefully, you encounter problems, take the unit to your local CLARKE dealer. -
Page 4: General Safety Precautions
• Do not carry out any alterations or modifications to the tool. • The tool should be serviced as required by your CLARKE dealer. • Never use the tool if it is defective or operating abnormally. • ALWAYS ensure the workpiece is firmly secured leaving both hands free to control the tool. -
Page 5: Air Supply Requirements
• Always disconnect from the air supply when: Performing any maintenance. The tool is not in use. The tool will be left unattended. Moving to another work area. • Avoid damaging the tool for example by applying excessive force. • ALWAYS maintain the tool with care. Keep it clean for best and safest performance. -
Page 6: Assembly
1. Remove the plastic blanking plug from the connection port of the tool as shown in Fig 1. 2. Pour 2-3 drops of CLARKE airline oil into the air inlet. This should be done regardless of whether or not a lubricated air supply is to be used. -
Page 7: Operation
2. If the tool is not to be used for longer than 24 hours, run a few drops of CLARKE airline oil into the air inlet and run the tool for a few seconds to ensure that the oil has been well distributed throughout the tool. -
Page 8: Maintenance
**Clarke Airline Oil is available from your CLARKE dealer part no. 3050825. ACCESSORIES A wide range of accessories are available including filter/regulators, lubricators, high pressure hoses, etc. -
Page 9: Troubleshooting
. s t l l i . f f In the event that any of the above situations occurs, requiring the dismantling and overhaul of the tool, contact your CLARKE International Service Department on 020-8988-7400. -
Page 10: Parts Lists And Diagrams
PARTS LIST AND PARTS DIAGRAM n i l... -
Page 11: Technical Specification
I " 4 " 4 Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. -
Page 12: Vibration Emissions
VIBRATION EMISSIONS HAND-ARM VIBRATION Employers are advised to refer to the HSE publication “Guide for Employers”. All hand held power tools vibrate to some extent, and this vibration is transmitted to the operator via the handle, or hand used to steady the tool. Vibration from about 2 to 1500 herz is potentially damaging and is most hazardous in the range from about 5 to 20 herz. - Page 13 You will note that a third value is given in the specification - the highest measured reading in a single plane. This is the maximum level of vibration measured during testing in one of the axes, and this should also be taken into account when making a risk assessment.
-
Page 14: Declaration Of Conformity
DECLARATION OF CONFORMITY... - Page 15 DECLARATION OF CONFORMITY...