Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Clarke CAT113
Summary of Contents for Clarke CAT113
- Page 1 CUT OFF TOOL MODEL: CAT113 Part No: 3120135 ASSEMBLY & INSTRUCTION MANUAL LS0309...
-
Page 2: Environmental Protection
GUARANTEE This CLARKE product is guaranteed against faulty manufacture for a period of 12 months from the date of purchase. Please keep your receipt as proof of purchase. -
Page 3: Safety Precautions
SAFETY PRECAUTIONS WORK ENVIRONMENT • Keep the work area clean and tidy. • Dress appropriately - Do not wear loose clothing or jewellery. • Tie long hair out of the way. • Do not operate the cut off tool where there are flammable liquids or gases. •... - Page 4 SAFETY PRECAUTIONS • Always disconnect from the air supply when: a) Performing any maintenance b) The cut off tool is not in use. c) The cut off tool will be left unattended. d) Moving to another work area. e) Passing the cut off tool to another person. •...
-
Page 5: Air Supply
AIR SUPPLY WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU ARE THOROUGHLY FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF COMPRESSORS AND COMPRESSED AIR SUPPLY. The recommended procedure to connect this tool to an air supply, is shown on the right. We recommend that an automatic in-line filter- regulator-lubricator is used. -
Page 6: Before Use
(located here) 3. Check and clean the air inlet gauze filter. 4. Pour 2-3 drops of Clarke air line oil (approx. 3 cc), into the air inlet. This should be carried out regardless of whether or not an air line lubricator is used. -
Page 7: Changing The Cutting Disc
Ensure that the spacer is in place. IMPORTANT: The use of parts other than CLARKE replacement parts may result in safety hazards, decreased tool performance and may invalidate your warranty. Replacement cutting discs are available from your Clarke dealer. Part number 3110731... -
Page 8: Maintenance
If the tool is to be stored, or is idle for longer than 24 hours, run a few drops of Clarke air line oil into the air inlet, and run the tool for 5 seconds in order to lubricate the internal parts. -
Page 9: Technical Specification
TECHNICAL SPECIFICATION Please note that the details and specifications contained herein, are correct at the time of going to print. However, CLARKE International reserve the right to change specifications at any time without prior notice. " 3 l n i z i s "... -
Page 10: Parts Diagram + List
PARTS DIAGRAM + LIST l l a n i l l n I... -
Page 11: Declaration Of Conformity
DECLARATION OF CONFORMITY...