Using Coaxial (Good) - Insignia NS-42D40SNA14 User Manual

Insignia 39" LED TV

Using coaxial (good)

On your TV
Coaxial cable
connector
ANT/CABLE IN
jack
1 Make sure that your TV's power cord is unplugged and all connected equipment is turned off.
2 Connect the incoming cable from the cable wall jack to the cable-in jack on the cable or satellite box.
3 Connect a coaxial cable (not provided) to the ANT/CABLE IN jack on the back of your TV and to the coaxial out
jack on the cable or satellite box.
4 Plug your TV's power cord into a power outlet, turn on your TV, then turn on the cable or satellite box.
5 Press INPUT to open the INPUT SOURCE list.
6 Press or to highlight TV, then press ENTER.
7 If you cannot tune to channels you know exist, scan for channels. See
page 54.
Notes
• Use a coaxial cable to eliminate interference and noise from radio
• Do not bundle the coaxial cable with the power cord or other cables.
waves.
www.insigniaproducts.com
Back of TV
Cable or
satellite box
Coaxial cable
"Automatically scanning for channels" on
17