Gigabyte GA-G41MT-S2 User Manual page 22

CMOS Setup Utility-Copyright (C) 1984-2011 Award Software
x CAS Latency Time
x tRCD
x tRP
x tRAS
>>>>> Advanced Timing Control
` Advanced Timing Control
******** Mother Board Voltage Control ********
Voltage Types
-----------------------------------------------------------------------------
>>> CPU
CPU Vcore
CPU Termination
>>> DRAM
DRAM Voltage
: Move Enter: Select
F5: Previous Values
Whether the system will work stably with the overclock/overvoltage settings you made is dependent
on your overall system configurations. Incorrectly doing overclock/overvoltage may result in damage
to CPU, chipset, or memory and reduce the useful life of these components. This page is for advanced
users only and we recommend you not to alter the default settings to prevent system instability or
other unexpected results. (Inadequately altering the settings may result in system's failure to boot. If
this occurs, clear the CMOS values and reset the board to default values.)
Robust Graphics Booster
&
Robust Graphics Booster (R.G.B.) helps to enhance the performance of the graphics chip and memory.
Auto allows the BIOS to automatically set the R.G.B. mode based on system configurations. Options are:
Auto (default), Fast, Turbo.
CPU Clock Ratio
& (Note)
Allows you to alter the clock ratio for the installed CPU.
The item is present only if a CPU with unlocked clock ratio is installed.
Fine CPU Clock Ratio
&
Allows you to increase clock ratio by 0.5 for the installed CPU.
The item is present only if a CPU with unlocked clock ratio is installed.
CPU Frequency
&
Displays the current operating CPU frequency.
******** Clock Chip Control ********
>>>>> Standard Clock Control
CPU Host Clock Control
&
Enables or disables the control of CPU host clock. Enabled will allow the CPU Host Frequency item below
to be configurable. Note: If your system fails to boot after overclocking, please wait for 20 seconds to allow
for automated system reboot, or clear the CMOS values to reset the board to default values. (Default:
Disabled)
(Note) This item is present only when you install a CPU that supports this feature.
MB Intelligent Tweaker(M.I.T.)
9 Auto
9 Auto
9 Auto
24 Auto
[Press Enter]
Normal Current
1.17500V [Auto]
1.200V [Auto]
1.500V [Auto]
+/-/PU/PD: Value F10: Save
F6: Fail-Safe Defaults
(Note)
- 22 -
Item Help
Menu Level `
ESC: Exit F1: General Help
F7: Optimized Defaults