Power Management Setup - ECS PN1 SLI2 Extreme User Manual

Motherboard

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

KB Power On Password (Enter)

Press Enter and key in the password for Keyboard power on.

Hot Key Power ON (Ctrl-F1)

Use this item to allocate the hot key to wake up the system.

Onboard FDC Controller (Enabled)

This option enables the onboard floppy disk drive controller.

Onboard Serial Port 1 (3F8/IRQ4)

This option is used to assign the I/O address and interrupt request (IRQ) for onboard

serial port 1.

Onboard Parallel Port (378/IRQ7)

This option is used to assign the I/O address and interrupt request (IRQ) for the

onboard parallel port.

Parallel Port Mode (SPP)

Enables you to set the data transfer protocol for your parallel port. There are four

options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port), ECP (Extended

Capabilities Port) and ECP+EPP.

PWRON After PWR-Fail (OFF)

This item enables your computer to automatically restart or return to its last operating

status.

3-14

3.3-5 Power Management Setup

This option lets you control system power management. The system has

various power-saving modes including powering down the hard disk, turning

off the video, suspending to RAM, and software power down that allows

the system to be automatically resumed by certain events.

Phoenix-AwardBIOS CMOS Setup Utility