Installing Motherboard In A Case; Connecting Ide, Floppy & Sata Device; Installing Expansion Cards - ECS PN1 SLI2 Extreme User Manual

2.4 Installing Motherboard in a case

1. Place the motherboard over the mounting brackets.
2. Secure the motherboard with screws where appropriate.
3. Double check to make sure that the underside of the motherboard is
not touching the case or else shorting may occur and make sure that
the slots and I/O connectors line up with the holes on the back of
the case.
4. Case LED leads are labeled, connect the leads to the panel header on
the motherboard.
2.5 Connecting IDE, Floppy & SATA Device
1. If installing two IDE devices on the same
ribbon cable, one device must be set to
"master" and the other to "slave." Check
the accompanying documents for the
master/slave settings of IDE Devices, ie.:
the hard disk and CD-ROM drives and then
set their jumper caps accordingly.
2. Mount the drives in the case.
3. Connect the floppy disk ribbon cable and
power cable.
4. Connect the IDE ribbon cable and power
cable.

2.6 Installing Expansion cards

1. Open the chassis and then remove the slot bracket from the case
where you will be installing the expansion cards.
2. Install your graphics card in the proper slot by pressing the card
firmly into the slot.
IDE Hard Disk
Floppy Disk Device
SATA Hard Disk
2-3