Advertisement
Setting up the equipment you need for switching
Main
Point!
With four channels on the V-4 Video Mixer and
eight on the V-8, you have the ability to mix
multiple video inputs. You can connect video
sources according to the capacity of each unit.
The V-8 has inputs for the P-10, video cameras,
DVD or other types of video playback devices.
You can also connect a computer using a 15-
pin D-sub (VGA) connector. With this many
inputs, you can handle a wide variety of media.
Previewing is essential in many live situations,
and most video mixers have preview monitor
outputs. You can preview the final output and
the current status of each channel in case you
need to change the mixer settings or camera
position. Although not shown in the figure
■Typical devices connected to inputs
Personal computer
V-8 rear panel
■Typical devices
connected to outputs
Preview monitor
Mainly used to check final
output but can be used to view
each channel input.
014
■Have a preview monitor
■Allow ample time for load-in and setup
■Set a uniform aspect ratio (4:3 or 16:9) for your equipment
P-10 Video Sampler
TV monitor
below, the event can also be recorded if you
send the final video output to a video deck or
DVD recorder. The end result is a system that
can carry out live production and record the
final output.
Even though you may construct an elaborate
video production system, it is meaningless if it
is not used effectively. The time and effort
needed to load-in and set up such a system can
be time consuming. Carefully select the
appropriate items based on the number of
assistants and available space. Lastly, do not
forget to set your source outputs to the same
aspect ratio of your displays (e.g., 4:3 or 16:9).
DVD player, DV deck
Final output
Projector
DV camera
RCA−BNC adapter plug
The V-8 has BNC sockets
t o c o n n e c t p r o f e s s i o n a l
components and comes with
RCA/BNC adapters for sources
with RCA connectors.
Preview monitor
View the current image of each
channel.
Advertisement
