How To Use Accessory Tray; How To Stop Your Pressure Washer; How To Use The Adjustable Nozzle - Generac Portable Products 2100PSI Owner's Manual

2100psi
Hide thumbs Also See for 2100PSI:
Table of Contents

Advertisement

Available languages

Available languages

• Place your left foot on the lower frame and grasp the
handle as shown (Figure 15). Your unit may appear
slightly different from that shown here.
Figure 15 — Recommended Engine Starting Posture
• Pull the starter grip handle lightly with your right hand
until you feel some resistance, then pull briskly.
• Return the starter grip handle slowly. Do Not let rope
"snap back" against starter.
• When engine starts, slowly move choke lever to the
"Run" position. If engine falters, move choke lever to
the "Choke" position, then to the "Run" position.
• If engine fails to start after six pulls, move choke lever to
the "Run" position. If engine fires, but does not continue
to run, move choke lever to the "Choke" position, then
to the "Run" position.
NOTE: If the recoil starter is hard to pull, it may be necessary
to squeeze the gun trigger to relieve internal pump pressure.

How to Stop Your Pressure Washer

• Move throttle lever on engine to "Stop" position.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
Generac Portable Products 2,100 PSI High Pressure Washer

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your nozzle extension, and slots to hold the cleaning
solution bottle and the detergent siphoning filter. There are
also two hooks at the ends of the accessory tray to hold
your spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
• Place the nozzle extension through the hole on the
accessory tray, as shown in Figure 16.
Figure 16 — Typical Accessory Tray
• Hang your chemical solution bottle on the "J" hook and
place the detergent siphoning filter in the last slot on the
left (Figure 16).
• Hang the high pressure hose on the hook on the right
side of the accessory tray (Figure 16).
• Place the spray gun on the hook on the left side of the
accessory tray as shown on page 4.

How to Use the Adjustable Nozzle

You now should know how to START your pressure
washer and how to STOP it. The information in this
section will tell you how to adjust the spray pattern and
apply detergent or other cleaning chemicals.
CAUTION!
spraying. Never put hands in front of nozzle to
adjust spray pattern.
The adjustable nozzle affixed to the nozzle extension
permits you to adjust the spray pattern and the spray
pressure, as follows:
9
Never adjust spray pattern when

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

1536-1

Table of Contents