How To Use Accessory Tray; How To Stop Your Pressure Washer - Generac Portable Products 2700PSI Owner's Manual

2,700 psi
Hide thumbs Also See for 2700PSI:
Table of Contents

Advertisement

Available languages

Available languages

NOTE: For a warm engine, be sure the choke lever is in
the "Run" position.
• Grasp the unit's handle with your left hand. Pull the
starter grip lightly with your right hand until you feel
some resistance, then pull briskly.
• Return the starter grip handle slowly. Do Not let rope
"snap back" against starter.
• When engine starts, slowly move choke lever to the
"Run" position. If engine falters, move choke lever to
the "Choke" position, then to the "Run" position.
• If engine fails to start after six pulls, move choke lever to
the "Run" position. If engine fires, but does not continue
to run, move choke lever to the "Choke" position, then
to the "Run" position.
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.

How to Stop Your Pressure Washer

• Move throttle lever to "Stop" position.
• Turn the fuel shut-off valve to the "Off" position (fully
clockwise).
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
Generac 2,700 PSI Pressure Washer

How to Use Accessory Tray

The unit is equipped with an accessory tray with places to
store your nozzle extension and quick connect nozzles, and
slots to hold the cleaning solution bottle and the detergent
siphoning filter. There are also two hooks at the ends of
the handle to hold your spray gun and high pressure hose.
NOTE: The extra holes in the tray are for storing a brush
and a turbo wand. The brush and turbo wand are NOT
included with your pressure washer. You can buy these
items as optional accessories.
• Place the nozzle extension through the hole on the
• Hang your chemical solution bottle on the "J" hook and
• Place the spray gun on the hook attached to the
• Hang the high pressure hose on the hook attached to
9
accessory tray, as shown in Figure 16.
Figure 16 — Typical Accessory Tray
place the detergent siphoning filter in the last slot on the
left (Figure 16).
accessory tray on the right side of the unit (Figure 16).
the accessory tray on the left side of the unit as shown
on page 4.

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

1676-0

Table of Contents