Applying Detergent With The Adjustable Nozzle - Generac Portable Products 2100PSI Owner's Manual

• Slide the nozzle forward to adjust the spray to low
pressure mode (Figure 17). Slide the nozzle backward to
achieve high pressure.
Figure 17 - Adjusting Spray Pressure
Slide nozzle backward
for high pressure mode.
• Point the nozzle down towards a firm surface and press
the trigger to test the pattern (Figure 18).
Figure 18 — Test the Spray Pattern
• Twisting the nozzle adjusts the spray pattern from a
narrow pattern to a fan pattern (Figure 19).
Figure 19 - Adjusting Spray Pattern
Twist nozzle
counterclockwise for fan
spray pattern.
Generac Portable Products 2,100 PSI High Pressure Washer
Slide nozzle forward for
low pressure mode and
detergent application.
Twist nozzle clockwise
for narrow spray
pattern.
• For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from cleaning surface.
• If you get the spray nozzle too close, especially using high
pressure mode, you may damage the surface being
cleaned.
• Do Not get closer than 8 inches when cleaning tires.
Applying Detergent with the
Adjustable Nozzle
CAUTION!
You must attach all hoses before you
start the engine. Starting the engine without all the hoses
connected and without the water turned ON will damage
the pump.
IMPORTANT: Use soaps designed specifically for
pressure washers. Household detergents could damage
the pump.
To apply detergent, follow these steps:
• Review the use of adjustable nozzles.
• Prepare detergent solution as required by the
manufacturer.
• Hang the detergent solution on the "J" hook attached to
the accessory tray, as shown in Figure 20.
Figure 20 — Insert Filter into Container
• Place the small filter end of the detergent siphoning tube
into the detergent container.
CAUTION!
Keep the detergent siphoning tube from
coming in contact with the hot muffler.
• Slide the adjustable nozzle forward to low pressure
mode. Detergent cannot be applied with the nozzle in
high pressure position.
10