Table of Contents
Advertisement
NOTE: If the recoil starter is hard to pull, it may be
necessary to squeeze the gun trigger to relieve internal
pump pressure.
How to Stop Your Pressure Washer
• Move throttle lever on engine to "Stop" position.
• Squeeze trigger on the spray gun to relieve
pressure in the hose.
NOTE: A small amount of water will squirt out when you
release the pressure.
How to Use the Adjustable Nozzle
You now should know how to START your pressure
washer and how to STOP it.The information in this
section will tell you how to adjust the spray pattern and
apply detergent or other cleaning chemicals.
CAUTION!
Never adjust spray pattern when
spraying. Never put hands in front of nozzle to
adjust spray pattern.
The adjustable nozzle affixed to the nozzle extension
permits you to adjust the spray pattern and the spray
pressure, as follows:
• Slide the nozzle forward to adjust the spray to low
pressure mode (Figure 10). Slide the nozzle backward to
achieve high pressure.
Figure 10 - Adjusting Spray Pressure
Slide nozzle backward
for high pressure mode.
• Point the nozzle down towards a firm surface and press
the trigger to test the pattern (Figure 11).
1800 PSI Pressure Washer
Slide nozzle forward for
low pressure mode and
detergent application.
Figure 11 — Test the Spray Pattern
• Twisting the nozzle adjusts the spray pattern from a
narrow pattern to a fan pattern (Figure 12).
Figure 12 - Adjusting Spray Pattern
Twist nozzle
counterclockwise for fan
spray pattern.
• For most effective cleaning, keep the spray nozzle
between 8 to 24 inches away from cleaning surface.
• If you get the spray nozzle too close, especially using high
pressure mode, you may damage the surface being
cleaned.
• Do Not get closer than 8 inches when cleaning tires.
How to Use the Turbo Nozzle
The turbo nozzle rotates the high pressure stream in a
rapid circular pattern.The high pressure spray is most
effective when the tip of the nozzle extension is held
between 8 to 24 inches from the surface being cleaned.
Always start the turbo nozzle at a distance, gradually
getting closer to the surface until you get the cleaning force
you want.
8
Twist nozzle clockwise
for narrow spray
pattern.
Advertisement
Table of Contents
