The Remote Control Does Not Work - Epson EB-G6750WU User Manual

Problem Solving
Check
Is the projector volume set to the minimum?
Is the volume for the computer or from the image source set to the
minimum?
Is A/V Mute active?
Is the audio cable's specification "No resistance"?
Is it connected with an HDMI cable?
Is the correct audio input selected?

The remote control does not work

Check
Is the remote control light-emitting area pointing towards the
remote receiver on the projector during operation?
Is the remote control too far from the projector?
Is direct sunlight or strong light from fluorescent lamps shining onto
the remote receiver?
Is the correct setting for the Remote Receiver selected?
Are the batteries dead or have the batteries been inserted correctly? Make sure the batteries are inserted correctly or replace the batteries with new ones if necessary.
Are the remote control ID and the projector ID matched?
Adjust the volume so that sound can be heard.
s Settings - Volumep.84
s "Adjusting the Volume" p.42
Adjust the volume so that sound can be heard.
Press the [A/V Mute] button to release A/V Mute.
s "Hiding the Image and Sound Temporarily (A/V Mute)"
When using a commercially available audio cable, make sure it is labeled "No resistance".
If no audio is output when connecting via an HDMI cable, set the connected equipment to PCM output.
Check the Audio Settings from the configuration menu.
s Extended - A/V Settings - Audio Settings
Point the remote control towards the remote receiver.
s "Remote control operating range"
The operating range for the remote control is about 15 m.
s "Remote control operating range"
Set the projector up in a location where strong light does not shine onto the remote receiver.
Check the Remote Receiver from the Configuration menu.
s Settings - Remote Receiver p.84
s "Replacing the remote control batteries"
Make sure the ID for the projector you want to operate and the ID for the remote control match. To operate all projectors
by remote control regardless of the ID setting, set the [ID] switch on the remote control to Off.
s "ID Settings" p.28
Remedy
p.63
p.86
Remedy
p.15
p.15
p.14
118