Telephone Setting (North America Only) - Aiphone IS SERIES Setting Manual

Telephone setting (North America only)

For example, the following actions are possible by using
telephone. Refer to the "OPERATION MANUAL" for details.
• A communication is enabled between a sub station (other than
IS-IPDV and IS-IPDVF) and telephone by setting the master
station to transfer a call from a sub station to telephone.
• A door release or chime paging is possible from the registered
telephone set.
The following settings can be made for communicating with
telephone. Basically, use this function with the default setting.
However, some features may not operate correctly depending
on the exchange, PBX, etc. In that case, you may need to
change the corresponding setting below.
1 Click Telephone setting in the table of contents.
2 Set the following settings.
• [Telephone connection]:
Set whether or not to communicate with telephone (ON/
OFF).
• [Called telephone number]:
Enter up to 3 telephone numbers.
• [Call change time]:
Set the time for changing call to the next telephone
number when not answered from the current number.
• [Telephone pass code]:
Set the code used for door release operation/chime input
operation.
• [Dial pause duration]:
Set the duration between the outgoing call number and
telephone number.
• [DTMF duration]:
Set the dial tone sending time.
•
[Waiting time for ring-back-tone]:
Set the waiting time for ring-back-tone.
• [Telephone pass code input time]:
Set the time-out period of inputting the telephone pass code
for 1 digit.
• [Dial-tone detecting time]:
Set the dial-tone detecting time.
• [Sound detection waiting time]:
Set the waiting time for sound detecting.
• [Sound detection time]:
Set the sound detecting time.
• [Call detection time]:
Set the call detecting time.
38
Detection setting
Make the settings for detecting outgoing call.
Outgoing call tone detection
• [Dial-tone detection]:
Set to ON to detect dial-tone and send outgoing call
number. Set to OFF to confi rm the connection of
exchange and send outgoing call number.
• [Outgoing call tone detection priority]:
Give priority to either exchange signals or sound
detection as the method for detecting outgoing call tone.
Called party answer detection
• [Shorter ring-back-tone than previous one]:
Set ON/OFF of communication detection when
answering while dial-tone is sounding.
Set the "Ring-back-tone detection time" when set to ON.
• [End of ring-back-tone]:
Set ON/OFF of communication detection when
answering while dial-tone is not sounding.
Set the "Waiting time for ring-back-tone" when set to ON.
Called party hang-up detection
• [Busy tone detection]:
Set detection ON/OFF of busy-tone received from the
exchange for ending communication.
• [Dial tone detection]:
Set detection ON/OFF of dial-tone received from the
exchange for ending communication.
• [CPC signal detection]:
Set detection ON/OFF of CPC signal from the exchange.
Set the "CPC signal detection time" when set to ON.
• [Reverse polarity detection]:
Set detection ON/OFF of reverse polarity.
3
Click
Temporarily stored
results temporarily.
If you wish to cancel the setting results you have made,
*
click a title in the table of contents or "Refresh" in the
web browser menu.
to save the current setting